Features: The Platform Cable USB is a USB-compatible cable for in-circuit configuration and programming of all Xilinx devices. It derives all operating power from the USB hub port controller; no external power supply is required. A sustained slave-serial FPGA configuration transfer rate of 24 Mbps is possible in a Hi-Speed USB environment. Built with the CY7C68013A and XC2C256 solution, it fully supports the Xilinx Platform Cable USB. It supports all Xilinx devices for FPGA configuration and PROM or CPLD programming. Supports JTAG, Slave-Serial, and SPI interfaces. Interfaces with devices operating at 5V (TTL), 3.3V (LVCMOS), 2.5V, 1.8V, and 1.5V. Selectable target clock frequency with software automatic frequency adjustment. Compatible with Windows and Red Hat Enterprise Linux. Automatically senses and adapts to target I/O voltage. Target clock speeds are selectable from 750 kHz to 24 MHz. Specifications: Size: Approx. 110 × 50 × 20 mm (4.33 × 1.97 × 0.79 in) Model: DLC9LP Power: 5 V, 0.07 A Supported Software: Xilinx ISE 8 through ISE 14.7, Xilinx Vivado, IMPACT, ChipScope, MicroBlaze embedded processor debugging Supported Devices: All Xilinx devices including Virtex and Spartan FPGA families; XC9500, XC9500XL, XC9500XV CPLDs; CoolRunner-XPLA3 and CoolRunner-II CPLDs; XC18V00 ISP PROMs; Platform Flash XCF00S, XCF00P, XL PROMs; XC4000 series FPGAs; and newer Xilinx devices including Virtex-7 and Zynq-7000. Package Includes: 1 × Platform Cable USB 1 × JTAG adapter 1 × USB 2.0 cable 1 × 8-pin to 7-pin separated ribbon cable 1 × 14-pin (2.5 mm pitch) JTAG flat cable 1 × 14-pin (2 mm pitch) JTAG flat cable 1 × 10-pin (2.5 mm pitch) JTAG flat cable