Feature: 1. The whole body is waterproof, rainwater cannot enter the inside when it rains, which greatly improves the service life of the product. 2. Large‑capacity removable battery, hanging hole design, when the screen displays "LB", unscrew the bottom screw, you can replace the battery. 3. The large screen automatically displays, the data is accurate, and the 3 digits display makes the numbers more intuitive. 4. Waterproof switch design, the switch button is protected by a rubber sleeve, easy to use, located on the lower side of the handle. 5. The arc probe is smoothly, customized according to the characteristics of the animal, reducing the interference to the animal during pregnancy. Specification: Item Type: Pig Estrous DetectorMaterial: PEColor: As Picture ShownProbe Length: Approx. 30cm/11.8inWeight: Approx. 735.0g/25.9ozPurpose: Pig ovulation test, detection of pig estrus and mating time Battery: Carbon Battery 6F22x1 (800mAh) (built-in) Working Temperature: 0-50℃ How to use: 1. Please clean the probe and probe of the instrument before use. It is recommended to use household detergent, get a cotton cloth to wet, put the detergent on the cotton cloth, and then wipe the probe and probe repeatedly, especially the probe part must be sufficient Wipe, because the probe is used to measure the resistance value of the mucus during the estrus of the female animal, so we must ensure the cleanliness of the probe. Finally, rinse it with water and use it directly. Don’t wipe it dry after flushing. Water drops will not affect it. Test Results. 2. Please keep the tested female animal in a static state, do not move, tilt the instrument slightly and then insert it into the female animal’s cervix in parallel, until it can’t move. After inserting it, rotate the instrument for two weeks and fix it in this position. Don’t move it, click the switch, and “--” will flash on the display, and then the data will be displayed. Click the switch again, and the second set of data will appear on the display. Then click the switch a third time, and the third set of data will appear on the display. When reading these three sets of data, do not move or change the position of the probe, do not pull it out and plug it in again, do not rotate the device every time one set of data is taken. 3. To ensure the accuracy of the data, the two sets of data that are close to each other are used as test records. When the pig is not in heat, the data is above 400 After entering the estrus period, the data will start to fall from above 450, and will continue to fall to 250 or below (minimum 200), and continue for about one day, and then the data rises, when it rises to about 400, it enters the ovulation period. At this time, it is the first time. Then with a second time interval of 6-8 hours When the pigs are in heat for about three days, when the breeding is observed with the nake eye, that is, the physiologically significant characteristics indicate the breeding, and the measured data can rise to 400 and above for breeding. This is the reference standard for data changes in most pigs. We do not rule out that the estrus is not obvious, abnormal, and recessive, but pigs with any symptoms are applicable to the data change rule of the ovulation meter.. Package List: 1 x Pig Estrous Detector Note: 1. The insertion depth must be executed strictly according to the instructions, and the inspection depth and angle must be consistent each time.2. In order to ensure the accuracy of the data, do not move or change the location of the device during the detection process.3. The mother animal should be in a normal standing state.4. After inserting, it must be rotated for two weeks before testing. The minimum interval between two tests is two hours.5. Thorough cleaning should be carried out before and after the test to avoid infection and ensure the accuracy of the value.