Auto detection of K-Line/CAN, with option to bypass and force preferred communication protocol. Temporary immobilizer bypass to allow bench flashing on ME7. Boot mode support for ECUs with C167 and ST10 processors. EEprom read/write functions for select ECUs included. TPROT level checking for MEDC17 without opening the ECU. Install on Windows 7 system. Proper driver installation required before opening software; use driver from included CD, not drivers for other MPPS versions. This module adds support for advanced functions on various ECUs. MPPS supports a range of controllers including M3.8, M3.9, ME7xx, MED9, MED17, EDC15/16/17, Delco, Trionic, and others. Fitment: For 6JF - Full Read/Write and EEprom over K-line. For 8DF - Full Read/Write and EEprom over K-line. For 8F2 - Full Read/Write and EEprom over K-line and CAN. For 8F3 - Full Read/Write and EEprom over K-line and CAN. For 8GM - Full Read/Write and EEprom over CAN. For 8GS - Full Read/Write and EEprom over CAN. For 5SF3 - Full Read/Write Flash and EEprom over CAN. For 5SF3 - Full Read/Write EEprom over K-Line. For 5SF8 - Full Read/Write Flash and EEprom over K-line and CAN. For 5SF9 - Full Read/Write Flash and EEprom over CAN. Material: ABS plastic Color: Black Package Contents: 1 x MPPS V18.12.3.8 1 x Breakout Tricore Cable 1 x Connection Cable 1 x CD Only the above package content is included; other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture to appear slightly different from the actual item. Measurement may vary by +/- 1-3 cm.