Cautions: If the device cannot be remotely controlled, check that the barcodes on the emitter and receiver match, the emitter’s indicator light is functioning, the receiver cable is securely connected, and the buzzer emits a single beep upon power-on. If the receiver does not respond to the emitter, verify battery contact and power level; replace batteries promptly when low. Reduced remote sensitivity may result from environmental interference or low battery. Remove batteries if the device will not be used for an extended period. Wire the device strictly according to the specifications indicated on the labels—improper wiring may reduce lifespan or cause immediate failure. Do not connect the antenna to any other wires. If the fan has a code switch, set it to the highest speed before using the remote. The receiver emits an audible beep when the remote button is pressed. Ensure adequate space inside the fan canopy or install the receiver accordingly. Operating Voltage: AC 90–220V Working Frequency: 50–60 Hz Remote Control Distance: Over 20 meters Supported Encoding: 1527 learning code Operating Mode: 1527 remote control Load Capacity: - Ceiling Fan: Up to 300W - Incandescent Lamp: Up to 1000W - LED / Energy-saving Lamp: Up to 200W Do not exceed rated load. Remote Control Battery: 2 AAA batteries required (not included) Voltage Type: 220V / 110V Color: White + Black Material: Plastic Package Contents: 1 × Controller 1 × Remote Control 1 × Wall Mount Note: Variations in lighting and screen settings may cause slight color differences between the image and the actual product. Measurement tolerance: ±1–3 cm.