• Make sure that the nail plate is adequately prepared, completely clean, free of cuticles and slightly made rough with a buffer.• Clean the natural nail with Lint Free Pads saturated with pure acetone.• Apply a sufficient amount of Antifungal to the entire natural nail.• Clean again with Lint Free Pads saturated with pure acetone.• Apply a no acid primer - bonder on the entire surface of the natural nail (from the cuticles to the free edge) without touching the area of the cuticles and the lateral folds of the nail.*** The application of the primer is optional • Apply a thin layer of the desired Laloo base (base coat or Graphen base in the color we like).• Polymerize under a Led Lamp for 60'' or a UV Lamp for 120''.• Apply a first thin layer of the color of your choice.• Polymerize under a Led Lamp for 60'' or a UV Lamp for 120''.• Apply a second layer of the color of your choice and make sure to apply it properly in order to give full coverage.• Polymerize under a Led Lamp for 60'' or a UV Lamp for 120''.• Apply a layer of Blooming Gel without polymerization, create the design of your choice and wait until it "cracks" as much as you wish. • Polymerize under a Led Lamp for 60'' or a UV Lamp for 120''.• Apply a layer of Top Coat or No Wipe Top Coat or No Wipe Matte Top Coat and polymerize under a Led Lamp for 60'' or a UV Lamp for 120''.*** If you choose a top coat with a sticky surface, you must remove it in the end with the Cleaner Ultra Shine Effect by Laloo Cosmetics or a 70 degrees alcoholic lotion without glycerin or oils.*** If you choose a No Wipe Top Coat, you must after the polymerization process leave the customer's hand to "cool" down for 1-1½ minutes so that the polish gives all its shine.Finally, complete the semi-permanent manicure procedure by applying oils to restore the pH of the nail.TIP: For beautiful and delicate designs, use the liner brushes N° 00 or the Skinny brushes.