1. Automatically charges the battery. 2. The rectifier and brake circuit use an integrated module, offering improved heat dissipation and reliability. 3. Features a fully sealed, waterproof design with an IP67 protection rating. Note: Ensure the wind turbine generator’s output voltage matches the battery’s rated voltage. Connect in the following order: first connect the battery’s positive (red) and negative (black) terminals to the controller, then connect the wind turbine’s three-phase output wires (green) to the controller’s three-phase input terminals. Incorrect wiring—such as reversed polarity or misconnection—may cause system malfunction or permanent damage to the controller. Wiring Instructions: 1. Connect the battery’s positive and negative terminals to the controller’s red (+) and black (–) battery terminals. 2. Connect the wind turbine’s three-phase output wires to the controller’s three-phase input terminals (green wires). Specifications: 1. Maximum input AC voltage: 35V AC 2. Output voltage: 12V or 24V 3. Battery charge cut-off voltage: 14.5V ±0.3V (12V system) / 29V ±0.3V (24V system) 4. Maximum charging current: 15A (for 12V), 10A (for 24V) 5. Wind generator speed-limit voltage: 14.5V ±0.3V (12V system) / 29V ±0.3V (24V system) 6. Protection rating: IP67 7. Standby current consumption: 0.008A 8. Rated power handling: 800W 9. Maximum wind speed rating: 12 m/s 10. Operating temperature range: –35°C to +65°C 11. Input wiring configuration: Three-wire system 12. Control compatibility: Supports both 12V and 24V systems 13. Mounting method: Bolted installation 14. Warning: Do not reverse battery polarity—doing so may destroy the controller. Application: Wind turbine charge controller Color: Blue Material: Aluminum alloy Package Includes: 1 x Wind Turbine Charge Controller Note: Colors may vary slightly due to screen settings and lighting conditions. Slight measurement variations of 1–3 cm may occur.