["brand new and high quality\nMaterial: Plastic\nColor: See Pictures\nSystem Voltage: 6V, 12V\nOutput Current: 10A\nPower Range: ≤60W(6V), ≤120W(12V)\nOverload, Short Circuit Protection: Yes\nNo-load loss: ≤5mA\nCharge Loop Drop: ≤0.2V\nDisharge Loop Drop: ≤0.1V\nfor Protection Degree: IP30\nWorking Temperature: -40℃~55℃\nInstall and Method of Using:\nFirstly, determine the controller output mode , the device factory default setting is normally open mode .if you need to set for the pure light control mode or light control plus timing mode, you need to open the enclosure through set dip switch, changing the discharge mode\nWhen the for key set \"on\" is 1, the for key set \"off\" is 0, normally open, pure light control\nConnecting the battery first. if correctly connected, battery indicator will light\nConnecting the wire of the solar panel second. if the connection is correct, the indicator light of “charge”will be on or flash 10 seconds later after laying outside under the for sun. otherwise, please check the connection\nMaking sure the solar energy panel is laid outdoors under the sunshine\nConnecting the load at the end. if inversely connected, the led lamp may be damaged\nPlease pay attention to the anode and the cathode to avoid the inverse connection\nSize: See the picture\nNo Retail Package\nQuantity: 1 Pc\nNote: Due to the difference between different monitors, the picture may not reflect  the actual color of the item. Thank you!"]