Condition: an 9001 facility to Easy installed and No modification needed,double side Automotive tape at the back Installation : 1. Clean the location of the installation with before proceeding. (make sure to remove any grease, wax or dust etc) 2. Please that the product completely fits before proceeding with installation. 3. Remove the high strength double-sided adhesive from the back of the plate. In the case of a relatively low temperature, heat installation location, and plate with a hair dryer or a heat on low setting 4. Carefully place the product in desired location and press down for about 1-2 minutes, (Note: do not wash your car for 24-hours. The adhesive should be cured after 12-hours) 5. The installation is complete Colour: black Material: PVC Package Contents: 3 x Gear Panel Water Cup Decoration Sticker Attention: Because the same model car may be differently produced in different country. Please the part of your car like our picture shows, or it will not fit Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.