1. The crossover is suitable for triple + + bass speakers. The speaker is suitable for 4-8 ohms. The finished products are also mainly used for better coordination. Sound quality, give debugging accessories at the same time of purchase. 2. The crossover is a finished product, which is connected to a of speakers. It is suitable for high and medium bass, and the sound quality is the ; not all speakers and all crossovers are the fit. After use, there may be too much or too little , low frequency and low frequency of the bass, low frequency or too thick bass, AND too much or too little high frequency component in the -range. Triple debugging: 1 - Right after connection, no need to debug. 2: Change the high- frequency component of the . 3: Change the high-pitched and high frequency components. Midrange debugging: 1: right after connection, no need for debugging. 2: Change the -high frequency component of the midrange to increase and decrease. 3: Change the low- frequency component of the midrange to increase or decrease. Bass debugging: 1: right after connection, no need for debugging. 2: Change the low- frequency component of the bass. 3: Change the low and frequency components of the bass to decrease. Product parameters: Frequency point: 1000HZ / 7000HZ (that is, the bass works at frequencies 1000HZ, the -range works between 1000HZ and 7000HZ, and the works above 7000HZ). Power: 200W. Impedance: 4-8 Ohm. Circuit: Determined by Debugging from 6db / oct to 12db / oct. colour: red Material: PCB Package Contents: 2 * Audio Speaker Crossover Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.