MCU FT232H high-speed multifunctional module USB to JTAG UART/FIFO SPI/I2C modname=ckeditor Typical Applications_x000D_ ? Single chip USB to UART (RS232, RS422 or RS485)_x000D_ ? USB to FIFO_x000D_ ? USB to FT1248_x000D_ ? USB to JTAG_x000D_ ? USB to SPI_x000D_ ? USB to I2C_x000D_ ? USB to Bit-Bang_x000D_ ? USB to Fast Serial Interface_x000D_ ? USB to CPU target interface (as memory)_x000D_ CJMCU-FT232H is a single channel USB 2.0 Hi-Speed (480Mb/s) to UART/FIFO IC. It has the capability of being configured in a variety of industry standard serial or parallel interfaces. The FT232H has the following advanced features:_x000D_ ? Single channel USB to serial / parallel ports with a variety of configurations._x000D_ ? Entire USB protocol handled on the chip. No USB specific firmware programming required._x000D_ ? USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible._x000D_ ? Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design._x000D_ ? UART transfer data rate up to 12Mbaud. (RS232 Data Rate limited by external level shifter)._x000D_ ? USB to asynchronous 245 FIFO mode for transfer data rate up to 8 Mbyte/Sec._x000D_ ? USB to synchronous 245 parallel FIFO mode for transfers upto 40 Mbytes/Sec_x000D_ ? Supports a proprietary half duplex FT1248 interface with a configurable width, bi-directional data bus (1, 2, 4 or 8 bits wide)._x000D_ ? CPU-style FIFO interface mode simplifies CPU interface design._x000D_ ? Fast serial interface option._x000D_ ? FTDIs royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases._x000D_ ? Adjustable receive buffer timeout._x000D_ _x000D_