Soft plastic PVC galvanized plastic electroplating car window rearview mirror door side bumper body door trim strip anti-collision protection stripSoft plastic PVC galvanized plastic electroplating car window rearview mirror door side bumper body door trim strip anti-collision protection strip The section is thick in the middle and thin on both sides (radian surface), the middle thickne is about 2 mm Installation Notes 1. Thoroughly clean the place where the car body needs to be pasted. If there is oil or wax, wipe it off with alcohol. 2. After tearing off the protective film on the back of the bright strip, stick it carefully, and then subtract the exce. 3. If the temperature is below 20 degrees, it is recommended to bake the adhesive with electric hot air before sticking to get good results. Do not wash the car within 1 day after sticking. Front window---length: 3-3.2m, width 2cm Rear window---length: 2.8-3m, width 2cm Rearview mirror---length: 0.3m, width 1cm Door side---length: 1m, width 1cm Upper light eyebrow---length: 1m, width 1cm Lower light eyebrow---length: 1m, width 1.5cm Four corners---length: 2m, width 1-2cm Front car circumference---length: 2.6-3m, width 1-2cm Rear car circumference---length: 2.8-3.2m, width 1.5-2cm Due to different models, the data is for reference only, and your measurement shall prevail