Name : BIEPUOrigin : CN(Origin)Placement on Vehicle : Hood and roofItem Height : 4cmItem Length : 25.5Material Type : PlasticItem Weight : 160gSpecial Features : car decoration air inletItem Width : 16.5cmApplicable models : most modelsProduct Description[Product name]: car decoration air inlet[Product size]: 25.5*16.5*4cm[Suitable models]: Basic universal typeThis product is for the purpose of decoration, it is only used to decorate the car, and has no real function of air intakeMost of the product itself is made of hard resin and cannot be installed on curved surfaces, hoods, etc.Purchase after confirming the installation location.Installation StepsBefore installation, Match the body and the surface of the car to confirm the installation position.At this time, decorate the inside of the wind net itself (the double-sided tape) as a whole, and find the grounding place (see whether it is curved).Caution If the product is installed in the curved place of the car body, if the product is damaged, there will be insufficient adhesion strength, and the product may fall off.Note When installing the door or the vicinity of the door, be sure to open and close the door in advance to ensure that there is no contact.After the installation position is determined, mark it when the protective film and the car body are matched.Note Please paste once carefully when pasting. If you re-open it and paste it again, the adhesive force will be weakened, so please be sure to paste it once.When the temperature is very low, use a hair dryer to heat the sticking surface before stickingPress the entire adhesive surface of the Duct, and press again to ensure that the paste is complete.Note Within 24 hours after installation, the adhesive strength of the double-sided tape will be weakened, so please avoid applying vibration or contact with waterInstallation note